Bullseye Get the app
Patent pending

Bullseye Ballistics · Auto Logging

Every shot logged the moment it's fired

The chronograph's reading starts the record. Bullseye fills in the rest.

With a chronograph and meters connected, each reading logs the shot instantly: its measured velocity, the wind and weather at the precise moment of the shot, what the solver dialed, the rifle, load, round count on the barrel, and more.

What goes into every logged shot

The chrono's reading is joined with everything else Bullseye knows at that instant, from your sensors, your phone, the solver and your profile, and written to the shot log as one entry. 44 data points per shot. Dashed fields record where a value came from (sensor, phone or typed).

ChronographLIVE3
Live over Bluetooth, the instant it reads
Measured velocityLogged by the chronoChrono timestamp
Wind meterLIVE4
Bluetooth wind meter, or typed
Wind speedWind directionTrue-north correctionWind source
Weather meterLIVE9
Bluetooth weather meter, or typed
Air temperaturePressureStation pressureHumidityAltitudeTemperature sourcePressure sourceHumidity sourceAltitude source
Phone sensorsLIVE7
Clock, GPS, compass and tilt (or an angle device)
Time of shotLatitudeShot direction (azimuth)Shot angleLatitude sourceDirection sourceAngle source
Firing solution6
What the solver dialed for this shot
Target rangePredicted dropPredicted windagePredicted velocityPredicted energyTime of flight
Rifle, load and barrel8
From the profile you're shooting
ProfileRifleLoadAmmo temperatureBarrelBarrel round countPhone that counted itMatch stage
Your call7
Tap or voice, added when you call it: "Hit", "Miss, .3 left" or "Miss, .3 low, .2 left"
Hit or missNo-callMiss locationMiss verticalMiss horizontalCold boreNote
SHOT LOG ENTRY
String Nov 9 #2 · Shot 6
44 fields, stamped once at the reading
Chronograph3
Wind meter4
Weather meter9
Phone sensors7
Firing solution6
Rifle, load and barrel8
Your call7

Conditions are captured when the chrono reads. Your call is added afterwards and never re-stamps them.

USED BY
Velocity checksWorkupsAdaptive MVTruingBarrel life

Call it when you're ready

The string line on the Solution screen shows Shot 6 · call it. Tap Hit or Miss, or say it, and the call is added to shot 6. A slow call still lands on the right shot, right up until the next reading arrives.

calls go to shot 6 Reading shot 6 logged, conditions stamped gust while you spot, not recorded "Hit" added to shot 6 Reading shot 7 logged

Your log follows the chrono

The shot log stays in step with what the chronograph recorded, without you tidying it up afterwards.

If you…The logged shot…
Call it Hit or MissGets your call, with the miss size if you give one
Don't call itStays as a no-call with its velocity, and doesn't count against your hit rate
Delete an uncalled shot on the chronoIs removed
Delete a called shot on the chronoKeeps your call and drops the velocity
Lose the connection mid-stringRecent missed shots are logged when the phone reconnects. Older ones still count toward the string's stats

Why the record of a single shot matters

Long-range accuracy is an exercise in error budgeting. Every shot that lands is the sum of a firing solution and a set of departures from it: a muzzle velocity a few feet per second off its average, a wind call that missed by half a mile per hour, a density altitude that drifted with the afternoon, a barrel that is 400 rounds further along its life than when the load was developed. Each departure is small. Their sum is the miss.

These departures can't be separated after the fact unless they were recorded at the moment of the shot. A hit rate tells you how often you were right. It can't tell you why you were wrong. That takes a record rich enough to attribute the error, and with measured velocity on every shot, Bullseye knows the velocity of the shot that only misses low during these conditions.

What the record makes possible

Separating the error sources

With prediction, conditions and outcome stored together, a miss becomes a residual. Vertical misses that track measured velocity point to the ammunition. Vertical misses that track temperature point to powder sensitivity. Horizontal misses that grow with time of flight and disappear when the wind came from a meter point to the wind call.

Wind or velocity

Wind drift depends on how much the bullet slows down, so a velocity that departs from the prediction carries into the wind hold too. With measured velocity on every shot, a horizontal miss can be divided into what the wind did and what the velocity did.

Truing from all your shots

Conventional truing adjusts MV and drag from one session at one or two distances. A log of fully described shots lets the same correction be estimated across many sessions, distances and atmospheres.

Velocity as a variable

Each shot's measured velocity sits next to its ammo temperature and barrel round count, so temperature sensitivity and the slow loss of speed as the throat erodes build up as a byproduct of ordinary shooting.

Barrel life

Every shot belongs to a rifle, a load and a barrel at a known round count. Changes in dispersion, velocity or first-round behavior can be placed against the round count where they appeared.

Honest statistics

Every input records where it came from. Shots fired on estimated conditions and shots fired on measured conditions can be analyzed separately, so data of uneven quality never quietly weakens a conclusion.

Analysis built on the record

Bullseye Ballistics AI (Sagitta) works directly on your shot log. Ask how much of your horizontal dispersion at 1000 yards is really velocity rather than wind, which wind directions you consistently misread at a given range, or whether your cold-bore shot still lands where it did 500 rounds ago. The answer is built from your own shots, and every number comes from Bullseye's own deterministic solver and statistics.

Auto Logging runs on the Solution screen. Chrono mode strings are saved as velocity checks or workup rungs, not as logged shots. Patent pending.